Trox Technik EM-IP, Configuration Manual, Page: 72 / 80

5.2.2 Replacing the EM-IP expansion
module
DANGER!
Danger of death due to electric current!
Danger of death if live components are touched.
– Switch off the supply voltage and secure it
against being switched on again before working
on the unit.
– Only skilled qualified electricians are allowed to
work on live components.
– Equipotential bonding is required.
Personnel:
 Skilled qualified electrician
Protective equipment:
 Protective clothing

Safety goggles
Materials:

EM-IP expansion module

Pin header
1. Open the housing cover on the EASYLAB/TROX
UNIVERSAL controller or on the TAM adapter
module (see installation and operating manual for
the device).
Removing the optional RTC module
Fig. 47: Removing the RTC module
2. Remove the fixing screw (Fig. 47/2) of the RTC
module (Fig. 47/1).
3. Remove the RTC module from EM-IP.
Removing the ground strap
Fig. 48: Removing the ground strap
4. Remove the fixing screw (Fig. 48/1) and washer
(Fig. 48/2), then detach the ground strap
(Fig. 48/4) from EM-IP (Fig. 48/3).
Removing EM-IP
Fig. 49: Removing EM-IP
5. Remove the fixing screws (Fig. 49/1) and washers
(Fig. 49/2), then remove EM-IP (Fig. 49/3) with the
pin header (Fig. 49/4).
Mounting a new EM-IP expansion module
Fitting the pin header
Fig. 50: Fitting the pin header
1. Take the pin header (Fig. 50/1) and push it with
the longer ends from below through the EM-IP
expansion module (Fig. 50/2).
Push the pin header just far enough so that the
pins protrude slightly on the upper side
(Fig. 50/3).
Maintenance
Maintenance > Replacing the EM-IP expansion module
Expansion module EM-IP 72