Triumph Adler CLP 4316, Instruction Handbook Manual

Page: 59 / 148

Using the Operator Panel
ADVANCED OPERATION GUIDE 2-33
6
Press
Z
. One of the following menus is indicated. To change settings for
the item, press [OK] ([ENTER]) . Use
U
or
V
to change the value or
selection.
7 Activate the appropriate protocol that is required to connect the printer to
the network. To activate a protocol, display the protocol, press
[OK]
([ENTER]) , press
U
or
V
to change from
Off
to
On
, and press [OK]
([ENTER]) .
8 Press [MENU] . The display returns to
Ready
. You can print a network
status page to confirm that the IP address, subnet mask address, and the
gateway address have been properly set. To print a network status page,
see
Printing a Network Interface Status Page on page 2-35 .
Resolving IP Address
To connect the printer to the network using TCP/IP protocol, you must set
the IP address on the printer. The IP address must be unique to the printer
and should be obtained from your network administrator.
1 Activate TCP/IP protocol in the manner
described above.
Set this item to
On
when you connect to a
network using NetWare. In submenu (
>
),
frame mode can be selected from
Auto
,
802.3
,
Ethernet-II
, and
802.2
.
>NetWare >
On
Set this item to
On
when you connect to a
network using TCP/IP. Submenu (
>
) has
items including DHCP, BOOTP, IP
address, subnet mask address, and
gateway address. To resolve IP address
for the network card, see
Resolving IP
Address on page 2-33 .
>TCP/IP >
On
Appletalk must be activated (
On
) for
networking with Macintosh computers.
>Appletalk
Off
When the item is set to
On
, the printer
prints out a network status page when it
prints the printer status. See
Printing a
Network Interface Status Page on page
2-35
.
>Network Status
Page Off
>TCP/IP >
On