Triumph Adler CLP 4316, Instruction Handbook Manual

Page: 60 / 148

Using the Operator Panel
2-34 ADVANCED OPERATION GUIDE
2
Enter the submenu by pressing
Z
. Each
time you press
U
or
V
, the selection
changes.
3
When
>>IP Address
is displayed, press
[OK] ([ENTER]) . A blinking cursor (
_
)
appears at the last digit.
4
Press
U
or
V
to increase or decrease, respectively, the value at the
blinking cursor. Use
Z
and
Y
to move the cursor right and left.
5
When the IP address is entered, press [OK] ([ENTER]) .
6 Press
U
or
V
to move to
Subnet Mask
. Perform the same procedure to
complete entering the subnet mask address.
7 Then, press
U
or
V
to move to
Gateway
. Perform the same procedure to
complete entering the gateway address.
8 Press [MENU] . The display returns to
Ready
. You can print a network
status page to confirm that the IP address, subnet mask address, and the
gateway address have been properly set. To print a network status page,
see
Printing a Network Interface Status Page on page 2-35 .
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
>>BOOTP
Off
>>DHCP
Off
>>IP Address
000.000.000.000