TrimTrac ProE Locator, Technical Manual

Page: 72 / 233

TrimTrac ProE Locator Technical Manual v2.0e 54
position (no regard to
motion). Can be used to
monitor specific
implements on the
equipment, such as PTOs. standard LPA input or if
Geofence Enforcement is
set “2=LPA Input
Enforced” or “3=LPA
Centered and Enforced”
Runtime LPA-based
Countdown, T30 Provides automatic reports
based upon runtime. Good
for maintenance, billing or
taxation.
Runtime Motion-based Good for monitoring when
equipment is being
transported or used. Can be
used on battery powered or
Module equipped TrimTrac
ProEs Can not distinguish between
runtime caused by
transportation or operation
Scheduled Hours Mode set
“1=Enabled” Prevents nuisance
transmissions during normal
working hours. Unit,
however, still logs position
information in the
background Start time same for each
workday. Consecutive
daily hours and workdays
only.
Scheduled Report Mode set
to “2=Weekly” Useful if equipment can be
idle for extended periods of
time
Geofence Enforcement Prevents nuisance
transmissions so long as
equipment is being used
where it supposed to be
used. If geofence established and
activated onsite via LPA
switch, then a module is
required. LPA switch can
not be used for geofence if
used for standard LPA input
or for Runtime LPA-based
GPS Fix Rate set “1=GPS
1Hz” Provides for more
continuous geofence
enforcement Substantially increased
power consumption while
in motion.
Table 23, Construction Equipment Monitoring Settings
Sample Construction Equipment Configuration
Settings
See
Page
AT+CTKC=43200,300,300,900,60,168,20,0,1,1,0 117
AT+CTKK=1,1,0,100,0,"+37.3842980","-122.0080760" 123
AT+CTKX=1,55785,1,1,60,3600,0,0,1,1,10,20,10,0 127
AT+CTKZ=10,1,55785,3600,1,5,1,0,100,0,1,1,0,1,50,0,0,0,0,0,0,0,0,0 134
Table 24, Sample Construction Equipment Monitoring Settings