TrimTrac ProE Locator, Technical Manual

Page: 17 / 233

TrimTrac ProE Locator Technical Manual v2.0e xvii
Firmware Release Notes
This manual covers the TrimTrac ProE with 2.03.00.000 firmware. Firmware changes
since 1.00.00.000 firmware are summarized in Table 1 through Table 5.
C
HANGE
S
UMMARY FROM
1.00.00.0000
TO
1.03.00.000
Schedule Hours Status flag added to Position Reports and Status Messages. If motion
triggered message is logged during after hours, than TriggerType shall be set
“2=Exception Report” and the Scheduled Hours Status flag shall be set “1=After Hours
Motion”
Low voltage cutoff added to prevent over-draining AA alkaline batteries. If battery
voltage drops below cutoff voltage, a new Status Message will be created and logged
with the Battery Level indicated as 999% indicating that a low voltage cutout has
occurred.
If a LPA-based geofence was re-centered while outside GSM coverage, the
device would continuously attempt to transmit a re-centering notice until the
device re-entered GSM coverage. In the meantime, no new position fixes would
be computed.
If LPA mode was not set to “1=Disabled” and the LPA input was used for geofence
enforcement, the device would skip the DELAY State.
All motion triggered messages will have a TriggerType set “2=Exception
Report” if one or more enforced conditions are violated, including Scheduled
Hours, Geofences, Speeding, or priority inputs (HPA, MPA, LPA).
1 Hz GPS enabled before entering FIX state if motion is detected and Motion
Report Flag is set “1=Enabled”
Speed Reporting expanded to include Speeding Report Mode and Speeding
Countdown Timer capabilities
RTKZ message and checksum error corrected. Start/Stop reporting corrected.
Table 1, Firmware Changes through v1.03.00.000