TrimTrac ProE Locator, Technical Manual

Page: 141 / 233

TrimTrac ProE Locator Technical Manual v2.0e 123
AT+CTKK Geofence Configuration
The AT+CTKK command configures the Geofence parameters. All Geofences
must be the same type as defined in AT+CTKZ or SET_EXT2_APP_CONFIG.
AT+CTKK=<Geofence ID>,<Geofence Enforcement>,<Reserved>,<Geofence
Delta X>,<Geofence Delta Y>,<Geofence Center Latitude>,<Geofence Center
Longitude>
OK
<Geofence ID> Unique geofence identifier 1 or 2
. Default:
1
<
Geofence Enforcement
>
0=Disabled; 1=Enforced; 2=LPA Input Enforced;
3=LPA Centered and Enforced.
. Default:
0
<
Geofence Schedule
>
0=24/7; 1=After Scheduled Hours; 2= During
Scheduled Hours. (See Scheduled Hours Mode)
.
Default:
0
<
Geofence Delta X
>
100s of meters (1 – 10000) Note: East-West length
of rectangular Geofence area or, if circular, the
diameter. 1=100 Meters
. Default:
1
<
Geofence Delta Y
>
100s of meters (0, 1 – 10000) Note: If set to “0”,
then circular Geofence area; else rectangular
Geofence area. 1=100 Meters
Default:
1
<
Geofence Center Latitude
>
WGS-84 Coordinates. Units of Degrees to 7
decimal places plus ‘+’ sign = North and ‘-‘ =
South.
(-90.0000000 to +90.0000000)
. Must be in quotation
marks. Default: “
+0.0000000
”
<
Geofence Center
Longitude
>
WGS-84 Coordinates. Units of Degrees to 7
decimal places plus ‘+’ sign = East and ‘-‘ = West.
(-180.0000000 to +180.0000000)
. Must be in
quotation marks. Default: “
+0.0000000
”
Table 38, AT+CTKK Assignment
Default: AT+CTKK=1,0,0,1,1,”+0.0000000”,”+0.0000000”
Default: AT+CTKK=2,0,0,1,1,”+0.0000000”,”+0.0000000”