TrimTrac ProE Locator, Technical Manual

Page: 176 / 233

TrimTrac ProE Locator Technical Manual v2.0e 158
JJJ MPA Transmit Attempts, N6 . 0=Until T16 Expires; 1-
255=Number of Tx Attempts before T16 expires. Default 0
KKK LPA Transmit Attempts, N7 . 0=Until T3 Expires; 1-
255=Number of Tx Attempts before T3 expires. Default 0
L
HPA Mode. 0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only. Default 0
M
0=Automatic; 1=Disabled; 2=Network Acknowledgement; 3=
Monitor-only.
WARNING:
Before inserting a Vehicle Adapter or Control
Module:
A) Connect the red (+) and black (-) wires to a 9-32 VDC
power source and install a 100k Ohm resistor across the
yellow wires; OR
B) Return MPA Mode to its default setting “1=Disabled”.
Default 1.
N
LPA Mode
.
0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only (regardless of motion)
.
Default
0
PPPPPPPP
Security Password
.
Always 8 alphanumeric characters, UPPER
CASE ONLY.
. Default 00000000
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 66, SET_MODULE_CONFIG Message
SET_PROV_CONFIG
The SET_PROV_CONFIG message is used by the server application to set the
SMS Communication values in the TrimTrac ProE. When received by the
TrimTrac ProE, the unit will send a RESP_PROV_CONFIG (page 178) message
in response.
>STKABBBBBBBBBBBBBBBBBBBBBBBB;PW=PPPPPPPP;ID=YYYYYYYY;
*ZZ<
A
TrimTrac Configuration Set: ‘V’ = Provisioning
Parameters
BBBBBB
BBBBBB
BBBBBB
BBBBBB
SMS Destination Address
.
24 characters including optional
international dialing “+” sign and country code for SMS messages.
Field padding in SPACES (not 0’s) before the international
dialing “+” sign. Default <Empty>.
PPPPPPPP
Security Password
.
Always 8 alphanumeric characters, UPPER
CASE ONLY.
Default 00000000
YYYYYYYY Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ Checksum.
Table 67, SET_PROV_CONFIG Message