Toyota Sienna 2021, Manual

Page: 486 / 600

486
7-2. Steps to take in an emergency
level after inflation for 25 minutes
with the switch on, the tire is too
damaged to be repaired. Turn the
compressor switch off and con-
tact your Toyota dealer.
• If the tire inflation pressure
exceeds the recommended level,
let out some air to adjust the tire
inflation pressure. (

P.487, 523)
14
With the compressor switch
off, disconnect the hose from
the valve on the tire and then
pull out the power plug from
the power outlet socket.
Some sealant may leak when the
hose is removed.
15
Install the valve cap onto the
valve of the emergency
repaired tire.
16
Attach the air release cap to
the end of the hose.
If the air release cap is not
attached, the sealant may leak and
the vehicle may get dirty.
17
Temporarily store the bottle
in the trunk while it is con-
nected to the compressor.
18
To spread the liquid sealant
evenly within the tire, imme-
diately drive safely for about
3 miles (5 km) below 50 mph
(80 km/h).
19
After driving, stop your vehi-
cle in a safe place on a hard,
flat surface and reconnect
the compressor.
20
Turn the compressor switch
on and wait for several sec-
onds, then turn it off. Check
the tire inflation pressure.
If the tire inflation pressure is
below 19 psi (130 kPa, 1.3
kgf/cm
2
or bar): The puncture
cannot be repaired. Contact
your Toyota dealer.
If the tire inflation pressure is
between 19 psi (130 kPa, 1.3
kgf/cm
2
or bar) and a point
below the recommended
level: Proceed to step
21
.
If the tire inflation pressure is
at the recommended level:
Proceed to step
22
.
A
B
C