4-20
730CDT
7.
Remove
two flat M3x4
screws
securing the HDD to the case and lift out the
HDD.
8.
Carefully pull off the HDD connector.
Figure 4-17 Removing the HDD
Installing the Hard Disk Drive
To install the hard disk drive, follow the steps below and refer to Figures 4-17 back through
4-15.
1.
Connect the
HDD connector
.
2.
Seat the
HDD
in the case and place the HDD connector holder into the
long tab
.
3.
Secure
two flat M3x4
screws
.
4.
Put the HDD
cover
in place; then place your hand on the cover and press lightly
to ensure the cover seats completely. Verify the HDD connector is seated
properly.
5.
Secure
four flat M3x4 screws
, then apply a new
VOID seal
. Do not re-use the
old one.
6.
Turn the computer upside down, slide the
LED indicator cover
to the left, and
rotate the cover up.
7.
Insert the
HDD
,
VOID label
side up, and press to ensure a firm connection.
8.
Install the optional PC card, optional memory module, and battery pack as
described in Sections 4.4 back through 4.2.
Summary of Contents for Tecra 730CDT
