Pre-installation
Step 9: Use Stand-alone Base Station Test Stand
14
Strata AirLink Installation Guide 5/00
Substep B: Set Up Base Station
1. Determine the best location for a Base Station. See
“Review System Component Placement”
on
Page 6
for more information.
2. Temporarily place the Stand-alone Base Station Test Stand as close as possible to the selected
Base Station location with the proper orientation (vertical or horizontal).
Note
When testing with a Base Station, be sure to rotate all four antennas to a 90° angle.
3. Plug the Base Station power supply into the +5VDC connector of the test stand (located on the
bottom) and into a 110VAC outlet.
4. Watch the LEDs on the front of the test stand until all red LEDs are out and only the green
LED is lit.
Substep C: Set Up Handsets
1. Make sure that your handsets
are fully charged.
2. Press
3:5
to turn on a
handset.
3. Enter
and press
)&1
to
access System Configuration.
4. Press
)&1
again.
5. Enter
.
6. Press
▼
(right of
$%&
).
7. Enter
.
8. Press
(1'
.
The handset returns to idle.
9. Repeat Substeps 1~8 for each
handset, substituting a
different HID number (for
example, 2, 3, 4, 5, etc.) in
Substep 7.
S Y S T E M
C O N F I G
1 2 : 1 5
S I D # 0
1 2 : 1 5
H I D # 0
1 2 : 1 5
Summary of Contents for Strata AirLink
Page 6: ...Contents Chapter 5 Maintenance and Troubleshooting iv Strata AirLink Installation Guide 5 00 ...
Page 10: ...Introduction Related Documents Media viii Strata AirLink Installation Guide 5 00 ...
Page 28: ...Pre installation Step 10 Mount Base Stations 18 Strata AirLink Installation Guide 5 00 ...
Page 106: ...Maintenance and Troubleshooting Troubleshooting 96 Strata AirLink Installation Guide 5 00 ...