Pre-installation
Step 1: Check System Hardware and Software Requirements
6
Strata AirLink Installation Guide 5/00
Step 1: Check System Hardware and Software
Requirements
Table 1
lists the minimum hardware and software that your PC must have to use the Strata AirLink
Manager software.
Important!
Windows 3.11/3.1 is a 16-bit application and the Manager software is 32-bit. To run
the Manager software, a special 32-bit support expansion is required.
Step 2: Review System Component Placement
A review of component placement before installation will help to reduce or eliminate attenuation.
Attenuation is loss of RF signal strength due to distance, antenna positioning, and/or obstructions.
The loss is measured in decibels (dBs).
Increases or reductions of three dBs result in doubling or halving signal strength. Try to limit the
total loss to 100 dBs (see
Figure 3
).
Figure 3
Loss of Signal Strength by Distance (Direct Line of Sight)
Table 1
Hardware and Software Requirements
Minimum
Recommended
Hardware
386DX 33 MHz
486DX2 66 MHz
Hard Drive
1.5MB
3MB
Random Access Memory
(RAM)
4MB
8MB
Video
VGA
SVGA
Mouse
Any supported by Windows
Same
Floppy Drive
1.44 MB 3.5 inch
Same
Software
Microsoft Windows 3.11/3.1
Windows 98/95
1
10
20
50
100
-30
40
-50
60
-62
72
-78
88
-90
100
2974
Power:
Loss:
Base
Station
Distance in Meters
dB
Summary of Contents for Strata AirLink
Page 6: ...Contents Chapter 5 Maintenance and Troubleshooting iv Strata AirLink Installation Guide 5 00 ...
Page 10: ...Introduction Related Documents Media viii Strata AirLink Installation Guide 5 00 ...
Page 28: ...Pre installation Step 10 Mount Base Stations 18 Strata AirLink Installation Guide 5 00 ...
Page 106: ...Maintenance and Troubleshooting Troubleshooting 96 Strata AirLink Installation Guide 5 00 ...