– 106 –
Drain pipe
U groove
Bearing base
70.5mm
Joint
No.
8
Part name
Cross flow
fan
(Continued)
Procedures
<Caution at reassembling>
1) At assembling work of the bearing base, check
that the drain pipe is surely incorporated in the
back body.
(Otherwise, water leak is caused.)
2) To incorporate the fan motor, remove the fan
motor rubber (at shaft core side), incorporate
the motor into the position in the following
figure, and then install the fan motor.
• Install the cross flow fan so that the right end
of the 1st joint from the right of the cross flow
fan is set keeping 70.5 mm from wall of rear
plate of the main unit.
• Holding the set screw, install the cross flow
fan so that U-groove of the fan motor comes
to the mounting hole of the set screw.
• Perform positioning of the fan motor as follows:
• When assembling the fan motor, the fan
motor must be installed in such a way that the
fan motor leads will be taken out is positioned
at the bottom front.
• After assembling the two hooking claws of the
motor band (right) into the main body,
position the fan motor, insert it, and then
secure the motor band (right) using the two
fixing screws.
Remarks
