JUNE 2002 © TOSHIBA TEC
6 - 41
e-STUDIO550/650/810 FIRMWARE UPDATING
Jig connector
<<Laser ROM/PLG board>>
1. Open the right side upper cover.
2. Loosen a screw to open the connector cover.
3. Connect the downloading jig with the jig connector on the PLG board (ROM attached side upward).
Jig connector
<<RADF ROM/RADF board>>
1. Remove 1 screw and take off the connector cover on the ADF rear cover.
2. Insert the downloading jig into the jig connector of the ADF board (ROM attatched side
downward).