4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-33027
(Revised on OCT. 2013)
4.1 DISC CUTTER (B-EX204-QM-R)
4- 2
4.1 DISC CUTTER (B-EX204-QM-R)
All the following parts are supplied with the kit. Make sure you have all items shown below.
Cutter Unit (1 pc.)
Cutter Cover (1 pc.)
Harness Ass’y (1 pc.)
Cord bush (1 pc.)
M-4x6 Screw (2 pcs.)
FL-3x6 Screw (1 pc.)
Installation Manual (1 copy)
Cable Clamp (1 pc.)
Paper Guide for T2/T3 printer
Tag Paper (4 sheets) for adjustment
NOTE:
1. This module cannot be used together with the B-EX904-H-QM-R peel-off module or B-EX204-R-QM-R rotary
cutter.
When this cutter is used together with an RFID module, be sure to install the RFID module prior to the cutter.
2. When installing this module in the T2 or T3 printer, replace the Paper Guide that is initially attached to the
Cutter Unit with the one included in the module. (Refer to Page 4-2-1 “Adjustment Method for Paper Guide”)
3. Four sheets of Tag Paper included in this module are used to locate the Paper Guide in the proper position.
(Refer to Page 4-2-1 “Adjustment Method for Paper Guide”)
Paper Guide for T2/T3 printer
Paper Guide (initially attached)
