5. SYSTEM MODE
EO18-33027
5.6 TEST PRINT
5-62
Initial values when turning the power on
ISSUE COUNT
1 piece
PRINT SPEED
6”/sec.
B-EX4T1-G, B-EX4T2-G, B-EX6T2-G, B-EX4D2-G,
B-EX4D2-G
5”/sec.
B-EX4T1-T, B-EX4T2-T, B-EX6T2-T, B-EX4D2-T
3”/sec.
B-EX4T2-H
SENSOR
Transmissive sensor
ＰＲＴ
ＴＹＰＥ
B-EX4T1/EX4T2/EX6T2: Thermal transfer
B-EX4D2: Direct thermal
TYPE
Batch issue
LABEL LEN.
76 mm
PAPER
Enabled
Supplementary explanation:
・
Each fine adjustment parameter is effective for test print. However, the X-coordinate fine
adjustment is excluded.
・
When an error occurs during a test print, the error message is displayed and printing is stopped.
The error LED turns on and the online LED turns off.
・
The error is cleared by a depression of the [CANCEL] key or [ENTER] key, and the display returns
to the test print menu. The error LED turns off and the online LED turns on. Printing is not
automatically resumed after the error is cleared.
・
The label size greater than the image buffer length cannot be designated. If it is designated, the
printer prints data corresponding to the image buffer length then stops, or the printer stops because
of an error.
・
When the transmissive sensor is selected, the gap between labels shall be 3 mm.
•
For the B-EX4T1, the rotary cutter does not support the print speed of 10 ips or faster. When the rotary cutter
is mounted (regardless of the cut issue is specified), the print speed is corrected to 8 ips even if 10 ips is
selected.
•
For B-EX4T1-G, specifying less than 15.0-mm pitch label for 3 ips print speed or less than 30.0-mm pitch label
for 6 ips, printing is performed without cut.
•
For B-EX4T1-T, specifying less than 15.0-mm pitch label for 3 ips print speed, less than 25.0-mm pitch label
for 5 ips, or less than 38.0-mm pitch label for 8 ips, printing is performed without cut.
•
In the case of the B-EX4D2, even if the thermal transfer mode is selected for the PRT TYPE, it will be
automatically changed to the direct thermal mode.
