Toro Multi Pro 41394, Operator'S Manual

Page: 80 / 96

g032545
Figure 109
Section-Valve Actuator Shown (the agitation valve actuator
is similar)
1. Actuator (section valve) 3. Stem port
2. Retainer
3. Remove the actuator from the manifold valve.
Removing the Agitation-Manifold
Valve
1. Remove the quick connect pin that secures the
quick-connect coupler for the agitation hose to
the manifold for the agitation valve (
Figure 110 ).
g191301
Figure 110
1. Flange (pressure-filter
head) 4. Quick-connect pin
2. Flange (coupling adapter) 5. Quick-connect coupler
(agitation hose)
3. Flange clamp 6. Quick-connect fitting
(agitation-valve manifold)
2. Remove the 3 flange clamps that secure the
agitation-valve manifold to the flanges of the
pressure-filter head and the coupling adapter
(
Figure 110 ).
3. Remove the 2 flange-head bolts (1/4 x 3/4 inch)
and 2 flange locknuts (1/4 inch) that secure the
agitation-valve manifold to the valve support
(
Figure 111 ).
g191302
Figure 111
1. Manifold (agitation valve) 4. Flange-head bolt (1/4 x
3/4 inch)
2. Valve support 5. Gasket
3. Flange locknut (1/4 inch)
4. Remove the agitation-valve manifold and
gaskets from the machine (
Figure 111 ).
Note:
If needed, loosen the mounting hardware
for the pressure-filter head as needed to provide
clearance.
Note:
Retain the flange clamps, gaskets, and
quick-connect pins for installation in Installing
the Agitation-Manifold Valve (page 85) .
80