Toro Multi Pro 41394, Operator'S Manual

Page: 58 / 96

CAUTION
Components under the seat will be hot
if the sprayer has been running. If you
touch hot components, you may be
burned.
Allow the sprayer to cool before
performing maintenance or touching
components under the hood.
3. Align a drain pan under the engine oil filter
(
Figure 76 ).
g028169
Figure 76
1. Drain plug
2. Engine oil filter
4. Remove the old oil filter ( Figure 76 ).
Note:
Dispose of the used oil filter at a certified
recycling center.
5. Wipe clean the surface of the oil filter adapter of
the engine with a rag.
6. Fill the oil filter with the specified oil.
Note:
Allow the filter element to saturate with
oil.
7. Apply a thin coat of the specified oil to the rubber
gasket on the replacement oil filter.
8. Install the oil filter to the filter adapter and turn
the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter
an additional 1/2 turn (
Figure 76 ).
Note:
Do not overtighten the oil filter.
9. Wipe clean any residual oil.
Engine-Oil Quantity
5.1 L (5.4 US qt) with the filter; refer to Engine-Oil
Specification (page 57)
Changing the Engine Oil
Service Interval: After the first 50 hours
Every 200 hours Change the oil more often
when operating the machine under heavy load
or in high temperatures.
1. Align a drain pan under the drain plug ( Figure
76 ).
2. Remove the drain plug ( Figure 76 ) and allow the
oil to drain completely.
Note:
Check the drain plug seal for wear
and damage; replace the seal if it is worn or
damaged.
Note:
Dispose of the used oil at a certified
recycling center.
3. Install the drain plug into the drain port of the
engine oil pan and tighten the plug to 33 to 37
N∙m (24 to 27 ft-lb).
4. Tilt the passenger seat forward and align the
prop rod into the detent in the prop-rod-guide
slot.
5. Remove the oil-filler cap from the filler neck of
the valve cover of the engine (
Figure 77 ) and
slowly pour approximately 80% of the specified
amount of oil into the filler neck.
g195189
Figure 77
1. Low 4. Oil-filler cap
2. Full 5. Dipstick
3. High
6. Remove the dipstick and check the oil level in
the engine (
Figure 77 ).
7. Slowly add additional specified oil to bring the oil
level to the full mark on the dipstick (
Figure 77 ).
Important:
Overfilling the engine with oil
may cause damage to the engine.
58