8.
Install the cover onto the air-cleaner body and
secure the cover with the 2 latches (
).
Note:
Ensure that the dust valve is aligned
between the 5 to 7 o’clock position when viewed
from the end (
).
9.
Align the coolant-overflow tank to the
tank-support bracket and seat the tank firmly
(
).
Important:
Ensure that the pressure-relief
hose is routed forward and down, and the
tank-vent hose is routed rearward as shown
in
.
10.
Lower the passenger seat.
Engine-Oil Specification
•
Oil type:
API service classification SL or higher.
•
Oil viscosity:
refer to the engine oil viscosity
table below.
Engine Oil Viscosity Table
Ambient temperature range
Oil viscosity
Above 25°C (77°F)
SAE30, SAE10W-30, or
SAE15W-40
0°C to 25°C (32°F to 77°F)
SAE20 or SAE10W-30
0°C to 20°C (32°F to -4°F)
SAE10W or SAE10W-30
Toro Premium Engine Oil is available from your
distributor in either 15W40 or 10W30 viscosity. Refer
to the
Parts Catalog
for part numbers.
Checking the Engine Oil
Service Interval:
Before each use or daily Check the
engine oil level before you start the
engine for the first time.
Note:
The best time to check the engine oil is when
the engine is cool, before it has been started for the
day. If the engine was operated, allow the oil to drain
back down to the sump for at least 10 minutes before
checking.
The engine is shipped with oil in the crankcase;
however, the level of oil must be checked before you
first start the engine and after you have run it.
1.
Position the machine on a level surface.
2.
Remove the dipstick, located under the
passenger seat, and wipe it with a clean rag
(
).
Note:
Insert the dipstick into the tube and make
sure it is seated fully. Remove the dipstick and
check the oil level.
g195363
g195189
Figure 75
1.
Low
4.
Oil-filler cap
2.
Full
5.
Dip stick
3.
High
3.
If the oil level is low, remove the filler cap from
the valve cover (
) and pour oil into the
filler neck until the oil level is up to the Full mark
on the dipstick.
Note:
Add the oil slowly and check the level
often during this process. Do not overfill.
4.
Install the oil-filler cap (
).
5.
Install the dipstick firmly in place (
).
Changing the Engine Oil
Filter
Service Interval:
After the first 50 hours
Every 200 hours Change the filter more often
when operating the machine under heavy load
or in high temperatures.
1.
Remove the forward heat shield; refer to
Removing the Forward Heat Shield (page 50)
.
2.
Raise the seats.
57
