Toro Multi Pro 41394, Operator'S Manual

Page: 54 / 96

g002014
Figure 70
Right Boom
1. Grease fitting
3. Wipe off excess grease.
4. Repeat the procedure for each boom pivot.
Greasing the Actuator-Rod
Bearings
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Grease Type: No. 2 lithium grease.
1. Lower the outer spray sections to the
SPRAY
position.
2. Remove the hairpin from the clevis pin ( Figure
71 ).
3. Lift up on the section and remove the clevis
pin and slowly lower the section to the ground
(
Figure 71 ).
4. Inspect the clevis pin for any damage, replace
if necessary.
g013780
Figure 71
1. Actuator 4. Hairpin
2. Actuator rod 5. Clevis pin
3. Boom-pivot-pin housing
5. Swivel the rod-end bearing and apply grease
into the bearing (
Figure 72 ).
Note:
Wipe off excess grease.
g002015
Figure 72
Right Boom
1. Grease the rod-end bearing
6. Lift the spray section to align the pivot with the
actuator rod.
7. While supporting the spray section, insert the
clevis pin through both boom pivot and actuator
rod (
Figure 71 ).
8. With the pin in place, release the spray section
and secure the pin with the hairpin removed
previously.
54