Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
Quick-disconnect fitting
1
Assemble the sprayer tank fill fitting.
2
No parts required
–
Check the section-hinge springs.
3
No parts required
–
Remove the shipping bumper.
Media and Additional Parts
Description
Qty.
Use
Starter key
2
Operator's Manual
1
Engine owner's manual
1
Parts Catalog Instruction Card
1
Screen filter
2
Read the manuals before operating the machine.
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
If you have questions or need additional information regarding the spray control system, refer to the
Operator’s Manual
supplied with the system.
Important:
This sprayer is sold without spray nozzles.
To use the sprayer,
you must obtain and install the nozzles
. Contact your authorized Toro distributor for
information on the available section kit and accessories.
After you install your nozzles and before using the sprayer for the first time, adjust the section bypass
valves so that the pressure and application rate remains the same for all sections when you turn 1 or
more sections off. Refer to
Adjusting the Section Bypass Valves (page 28)
.
12
