Toro Multi Pro 41394, Operator'S Manual

Page: 56 / 96

7. Check the air-filter element for excessive
accumulation of dust, dirt, and debris (
Figure
73 ).
Note:
Do not clean the air-filter element if it is
dirty; replace the air-filter element if it is dirty.
8. Install the dust cap onto the air-cleaner body and
secure the cap with the 2 latches (
Figure 73 ).
Note:
Ensure that the dust valve aligns
between the 5 to 7 o’clock position when viewed
from the end.
9. Lower the passenger seat.
Replacing the Air-Filter
Element
Service Interval: Every 100 hours Replace the
air-filter element more often in dusty,
dirty conditions.
1. If you are installing a new filter, inspect the new
air-filter element for shipping damage, including
the sealing end of the filter.
Important:
Do not install a damaged filter.
2. Clean the dust cap and air-cleaner body ( Figure
73 ).
3. Lift the coolant-overflow tank up and off the
tank-support bracket (
Figure 74 ).
g032541
Figure 74
1. Coolant-overflow tank 5. Air-filter element
2. Tank-support bracket 6. Dust valve (5 to 7 o’clock
position)
3. Latch (dust cap) 7. Pressure-relief hose
4. Dust cap 8. Tank-vent hose
4. Loosen the 2 latches that secure the dust cap to
the air-cleaner body (
Figure 74 ).
5. Gently slide the old filter element out of the
air-cleaner body to reduce the amount of dust
dislodged.
Note:
Avoid knocking the filter element against
the air-cleaner body.
6. Clean the inside of the dust cap, air-cleaner
body, and dust valve with a damp rag (
Figure
73 and Figure 74 ).
7. Insert the air-filter element into the air-cleaner
body (
Figure 74 ).
Note:
Ensure that the filter is seated in the
air-cleaner body properly by applying pressure
to the outer rim of the filter element when you
install it. Do not press on the flexible center part
of the filter.
56