6
Installing the Winter Frame
Assembly
Parts needed for this procedure:
2
Hose cover
4
Cable tie
1
Winter frame assembly
6
Wheel and tire assembly
20
Lug nut
2
Coupler pin
2
Tracks
Procedure
1. Insert a 2 x 4 between the front bogie stop and
the frame to tilt the winter frame toward the rear
(Figure 41).
Figure 41
1.
2 x 4
2. On the traction unit, install hose covers onto the
loose hydraulic pressure and tank hoses and secure
with 2 cable ties each.
3. Loosen the pressure hose fitting at the pump and
rotate the fitting 45 degrees toward the front of the
machine (Figure 42).
Note:
Figure 42 is shown as viewed from under
the traction unit.
Figure 42
1.
Pump
2.
Pressure hosed fitting
(rotated 45 degrees)
4. Remove the two screws securing the floor plate
cover to the floor and remove the plate (Figure 43).
Figure 43
1.
Floor plate cover
2.
Mounting screws
5. Carefully roll the winter frame assembly into position
while routing the drive shaft through the frame tube
(Figure 44).
19
