Figure 27
1.
Harness
3.
Long cab wire (orange)
2.
Harness wire clips
4.
Cable tie
4. Inside the control panel, locate the pink wire with the
connector enclosed in a plastic bubble (Figure 28).
Carefully cut off the end of the plastic bubble and
plug the appropriate wire connector into it. Close
and latch the control panel cover.
Figure 28
1.
Pink wire with plastic bubble (cut off end of plastic bubble)
Note:
If an Auxiliary Power Kit is installed on the
machine, proceed as follows:
A. Unplug the pink wire from the auxiliary power
kit connector.
B. Plug the pink wire connector into the appropriate
connector on the new harness.
C. Plug the other harness connector into the
auxiliary power kit connector.
5. Route the other end of the harness under the rear
frame mount toward the left side of the machine
while inserting the harness wire clips into the holes
in the underside of the rear frame mount (Figure 27).
Note:
Make sure to route the wires away from any
hot, rotating or sharp objects. Secure the wires with
cable ties.
6. Connect the red harness wire to the fusible link.
7. Insert the fusible link connector through the rubber
boot on the positive battery cable.
8. Connect the fusible link to the positive battery post
(Figure 29).
9. Connect the black wire to the negative battery post
(Figure 29).
Figure 29
1.
Negative battery cable (-)
3.
Fusible link
2.
Positive battery cable (+)
4.
Black wire
10. Secure the wires to the cables with cable ties.
4
Installing the Skid Plate
Parts needed for this procedure:
1
Skid plate
2
Flange-head bolt (3/8 x 1-3/4 inches)
4
Flange nut (3/8 inch)
2
Bolt (3/8 x 1 inch)
Procedure
1. Position a suitable floor jack under the rear bumper
tube, raise the rear of the machine and support with
jack stands (Figure 30).
15
