Figure 109
1.
Jacking bolts
19. Route the hoses as follows:
•
Route the tank hose under the lift cylinder and
between the cylinder mounting brackets to the
valve (Figure 110).
•
Route the pressure hose along side the PTO
shaft to the valve (Figure 110).
Note:
To emphasis the hose routing, the hoses are
shown without the hose covers installed.
Figure 110
1.
Tank hose
2.
Pressure hose
20. Connect the drive shaft to the gear box shaft in the
winter frame and torque the bolts (5/16 inch) to
175-225 in-lb (20 to 25 N
⋅
m). Install the roll pin
Figure 111
1.
Pressure hose
4.
Cable tie
2.
Tank hose
5.
Bolts
3.
Hose cover
6.
Roll pin
21. With the winter frame against the rear frame, raise
the floor jack enough to remove the summer drive
tires (Figure 112). Install the winter tires with 2 lug
nuts per side.
Figure 112
1.
Summer drive tire
22. Adjust the floor jack to line up the 1.00 inch holes
in the frame and install a coupler pin on each side
(Figure 113).
39
