Figure 105
1.
Two mounting bolts (3/4 inch), washers and nuts (Right
side)
15. Roll the mower deck and frame forward and out
of the way.
16. Loosen the pressure hose fitting at the pump and
rotate the fitting 45 degrees toward the front of the
machine (Figure 106).
Note:
Figure 106 is shown as viewed from under
the traction unit.
Figure 106
1.
Pump
2.
Pressure hosed fitting
(rotated 45 degrees)
17. Remove the two screws securing the winter frame
floor plate cover to the floor and remove the plate
(Figure 107).
Figure 107
1.
Floor plate cover
2.
Mounting screws
18. Carefully roll the winter frame assembly into
position while routing the drive shaft through the
frame tube (Figure 108).
Figure 108
1.
Drive shaft
2.
Frame tube
Note:
If the rear of the cab is not high enough to
clear the control handles, evenly tighten the jacking
bolts on each side of the cab jack tube to raise the
rear of the cab (Figure 109).
38
