Figure 113
1.
Coupler pin
23. Adjust the floor jack or rock the cab with your
hands as required to install the bolts (3/4 inch) on
each side (Figure 114). Torque the bolts to 265 ft-lb
(359 N
⋅
m).
Figure 114
1.
3/4 inch bolts
2.
Coupler pin
Note:
The rear tires will need to be removed to
torque the rear bolts (3/4 inch). After torquing the
frame bolts, install the rear tires and torque lug nuts
to 65 to 85 ft-lb (88 to 115 N
⋅
m).
24. Insert a rubber mount onto each cab mount at the
rear mounting locations (Figure 115).
Figure 115
1.
Cab mount
2.
Rubber mount
25. Lower the cab into position by slowly and evenly
loosening the jacking bolts on each end of the
jacking tube (Figure 116).
Figure 116
1.
Jacking bolts
2.
Cab jack tube
26. At the rear mounting points, secure the cab to the
machine with a bolt (1/2 x 3 inches), steel washer
(1/2 x 2–1/2 inches), rubber washer (1/2 x 2–1/2
inches) and nut (1/2 inch) (Figure 117). Tighten all
four cab mount bolts until the rubber mounts are
compressed to a thickness of 7/8 inch (2.2 cm).
40
