For Sales and Support, Contact Walker EMD • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800 • www.walkeremd.com
DEFAULT PLC PROGRAM
The Axiom Plus ships with a default PLC program that will allow the
controller to run as a simple sequential controller with little or no
modifications to the PLC program. The default PLC program is also
installed on the computer’s hard drive along with the programming
software, so it can be reloaded if necessary.
Figure 12.32 - Default PLC Program Example
The user may need to change the inputs used in the default PLC
program to match the field wiring of the Axiom Plus. The Axiom
Plus does not use dedicated inputs or outputs for the enable input,
home switch, CW limit, CCW limit, enabled output, in position
output and fault output. The user can determine the interface that
is required and assign the inputs and outputs in the PLC program.
The following table is the I/O assignment and usage for the default
PLC program:
1 2 : P R O G R A M M I N G
12-44
