1-16
Service Information
TLDI 115A 2007
6. Test Run
1.
Start engine and check if gear shift can be made
smoothly.
2.
After warming up the engine, read tachometer to check
idling engine speeds specified below.
Complete test run during break-in operation.
7. Checks After Test Run
1.
Check that no water is present at engine.
2.
Check that no fuel leaks in the cowl.
3.
Check that no oil or water leaks at the engine.
4.
After test run, use flushing kit and fresh water to wash
cooling water path by idling engine.
Trolling Engine Speeds :
700 · 800 · 900 ±50 r/min
RPM
4.
Run at 3,000 r/min or half of WOT for initial 2 hours, then
at 4,000r/min or 3/4 of WOT for 1 hour.
5.
Check that shifting into reverse (R) will not tilt up outboard
motor and allow water to run into boat.
3.
Shift gear into forward (F) and at idle slow for
approximately 10 minutes.
1
1
High Tension Cable
Idling Engine Speeds :
700 · 800 · 900 r/min
RPM
Tachometer :
P/N. 3AC-99010-0
MD115A̲ch01̲E̲2校̲070529.qxd 07.6.6 5:36 PM ページ 16
