1-12
Service Information
TLDI 115A 2007
7) Installation of Outboard Motor (Rigging)
Check that outboard motor is fixed on the hull with
installation bolts and nuts securely. Check location of anti-
ventilation plate relative to boat bottom.
a
6) Fuel Line
Check that fuel tank contains sufficient amount of
gasoline, fuel line is connected and does not leak.
CAUTION
Supply only unleaded regular octane gasoline
into fuel tank. Never use fuel mixed with oil.
Use of fuel mixed with engine oil will cause
engine trouble.
8) Inspection of PTT Unit
1.
Operate PTT switch to check that outboard motor tilts
up/down smoothly.
2.
Operate PTT switch to check that tilting up/down outboard
makes no abnormal noise.
3.
Tilt up outboard motor and steer fully to the right and left to
check that cables and hoses do not interfere with each
other and with any part of hull.
4.
Tilt outboard motor down to check that trim meter
indicates the lowest position.
Test-run to determine the best installation
height.
a
5 - 25 mm (0.2 - 1.0 in)
Anti-ventilation plate standard position
a
:
5
〜
25 mm (0.2
〜
1.0in) below boat bottom
MD115A̲ch01̲E̲2校̲070529.qxd 07.6.6 5:36 PM ページ 12
