62
Press and release the device button: TileVision® (TV), satellite receiver (SAT) or DVD recorder/player (DVD) that
you wish to control. Press the function button you require. The LEDs will light to confirm that a signal is being
sent and which device is being controlled.
To select a different device to control, press and release the device button: TileVision® (TV) satellite receiver
(SAT) or DVD recorder/player (DVD) that you wish to control. Press the function button you require. The LEDs
will light to confirm that a signal is being sent and which device is being controlled.
TileVision® Codes
The TileVision® learning remote control is supplied with the TV device button set to the TileVision® TV22/FR1
and TV26/FR2 model remote control codes. If these remote control codes are accidentally erased, the three
digit code for the TileVision® is 368.
The remote control is preprogrammed with a library of codes covering all major device brands.
The full code lists for satellite receivers, DVD recorders/players and VCRs are available for
download from the TileVision® website www.tilevision.tv.
1
Locate the three digit code in the brand list, for the satellite receiver or DVD recorder/player that you wish
to control.
2
Press and hold down the Television (TV), satellite (SAT) or DVD recorder/player (DVD) device button until
the red light stays on.
3
Enter the three digit code using the number buttons 0–9.
4
As each digit is entered the red light will flash once and then remain on.
5
If the three digit code is correct the red light will go out. If the three digit code is incorrect the red light will
flash twice and then remain on.
6
Press the original device button again to exit the code entry mode.
Note: If a three digit code is not entered within 15 seconds the red light will flash twice and exit code entry
mode. Entering a three digit code will delete/erase the programmed buttons for that device.
Remote Control - How to Control a Device
Entering a Brand Code
