9
Please note –
All required cabling for additional inputs must be installed during the
installation of the back box.
First Fix Kit – Cabling
TV Aerial Feed
Pass the aerial lead in to the back box and leave approximately 400 mm of lead loose in the back
box. Terminate the aerial lead with a standard 75 Ω coax termination.
A TV Distribution Amplifier may be required if you are in an area of weak signal or if other
televisions are already being fed from the aerial. If in doubt, consult a qualified aerial technician.
If the TileVision
®
is to be used with a Sky™ digital receiver which has two RF outputs, the channel
can be changed on the Sky™ receiver using the TileVision
®
learning remote control via the
TileVision
®
. To use this facility install a good quality coaxial cable that runs directly from the RF2
outlet of the Sky receiver, or from the outlet of a Remote-Link amp, in a continuous uninterrupted
run.
The TileVision
®
will accept additional inputs from many sources and can be integrated with home
automation and interactive hotel TV systems. See pages 14 to 18 for specific information.
Installing the supplied single stereo speaker
To fit the speaker cut a single 208 mm diameter hole in the
ceiling using the template supplied. Position the template a
minimum of 16 mm from any joists. Do not to cut through
any joists, cables or pipes, etc.
A four and a half metre length of four core speaker
cable is supplied with the speaker. Feed one end of
the speaker cable in to the back box, leaving 400 mm
of cable protruding in to the back box. The cable
should then be run from the TileVision
®
back box to
the position of the speaker leaving any surplus cable in
the ceiling space.
The speaker terminals on the TileVision
®
and on the
stereo speaker are colour coded to match the colours of the
supplied four core speaker cable. To ensure that the stereo
speaker is connected correctly the individual leads must be
connected to their matching colours on both the TileVision
®
and the stereo
speaker.
To connect the speaker cable to the ceiling speaker lift one of the lugs to open a terminal and insert
the appropriately coloured conductor. After releasing the lug give the lead a slight pull to make sure
that the lead is gripped correctly. Connect all of the leads in the same manner.
Loosen all four screws by turning them counter clockwise until the clamps can move freely. Do not
remove the screws. Install the speaker in to the precut hole and orientate the speaker so left audio
will be heard on the left and right audio heard on the right. Turn the clamp screws clockwise until
they are tightened and the speaker is held firmly. Insert the speaker grille by gently pressing it into
place. The grille will fit tightly without causing any vibration.
Speaker fixing clamp
Left audio
Right audio
