8-30
Application and Configuration Examples
Operation
The drive is now configured as a Registration Indexing controller.
•
The servo parameters have been setup with the unloaded motor.
•
Motion is commanded through the inputs.
The firmware saves the parameters in EEPROM memory. Thus the drive can be power cycled and, after
power-up, will use the parameters selected in the steps above.
When motion is required:
1. Close the switch between J1-26 and J1-20 to enable the drive.
2. Close the toggle switch between J1-26 and J1-32 to start Index 0.
3. Close the toggle switch between J1-26 and J1-33 to simulate registration.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com