Thermo Scientific Dionex UltiMate 3000 Series, Operating Instructions Manual

Page: 94 / 270

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Page 86 Operating Instructions
5.2 Status Screen
When the self test was successful, the status screens appear on the front panel displays.
You can adjust the screen brightness or screen contrast to your requirements from
Chromeleon or on the front panel displays ( → page 125 for the pump display and page 131
for the column compartment display).
5.2.1 Pump Module
The status screen for the pump module shows the following information:
Nano Pump
Flow on
350 nl/min
764 bar
%A: 85
NC_Pump
Flow on
0.35 ul/min
764 bar
LoadingPump
Flow on
20.0 ul/min
2 bar
%B: 15 %A: 100 %B: 0 %C: 0
Fig. 42: Status screen (example) (here for the NCS-3500RS)
This information is
displayed ...
Description
Pump name The pump name is the name that you specified on the Pumps page, under the
related Pump Device Name , in the Properties dialog for the module in the
Chromeleon Server Configuration program ( → page 48).
Flow on or
Flow off or
Purge
Flow on appears when the pump delivers with the specified flow rate.
Flow off appears when the pump is not delivering.
Purge
appears when a purge cycle is running.
Flow rate When the pump is pumping, the display always shows the flow rate that the
pump is actually delivering. When a flow ramp has been set in Chromeleon, it
may take some time until the specified target flow is reached.
While is pump is idle, the nominal flow rate is displayed and the flow value is
flashing.
Pressure Shows the pressure in the unit that you specified on the Limits page in the
Properties dialog for the module in the Chromeleon Server Configuration
program ( → page 48).
%A, %B or
%A, %B, %C
Shows the components of the solvent in percent of the total flow.
Tip:
If the purge cycle for the NC pump is started from Chromeleon, 'Purging'
appears on the display. In addition, the component is indicated for which the
purge cycle is running