Thermo Scientific DensityPRO, Application Manual

Page: 64 / 101

DensityPRO Specific Parameters
Table C–1. DensityPRO specific parameters
Parameter Type R/W Description
ALARM_STATUS_FLAGS_1 ASF R Alarm and status flag set 1
Bit 0 - "Unused"
Bit 16 - "Process Alarm 1"
Bit 1 - "Unused" Bit 17 - "Process Alarm 2"
Bit 2 - "Standardization mode
active" Bit 18 - "Process Alarm 3"
Bit 3 - "Calibration mode active" Bit 19 - "Process Alarm 4"
Bit 4 - "lump mode active" Bit 20 - "Process Alarm 5"
Bit 5 - "Unused " Bit 21 - "Process Alarm 6"
Bit 6 - "scan mode" Bit 22 - "Process Alarm 7"
Bit 7 - "X-Ray Safeguard Active " Bit 23 - "Process Alarm 8"
Bit 8 - "CAL Cycle aborted" Bit 24 - "Process Alarm 9"
Bit 9 - "FIFO Full" Bit 25 - "Process Alarm 10"
Bit 10 - "Current over max or under
min" Bit 26 - "Process Alarm 11”
Bit 11 - "Power has been off" Bit 27 - "Process Alarm 12”
Bit 12 - "Hold(s) are active" Bit 28 - "Process Alarm 13"
Bit 13 - "Alternate time constant
active" Bit 29 - "Process Alarm 14"
Bit 14 - "Output on alternate
measurement" Bit 30 - "Process Alarm 15"
Bit 15 - "Keypad in use" Bit 31 - "Process Alarm 16"
ALARM_STATUS_FLAGS_2 ASF R Alarm and status flag set 2
Bit 0 - " Safeguard Mode Armed" Bit 16 - "Current output under min"
Bit 1 - "Unused" Bit 17 - "RAM Memory Error"
Bit 2 - "Sensor Under Range" Bit 18 - "PROM Checksum Error"
Bit 3 - "Sensor Over Range" Bit 19 - " Protected memory checksum
error"
Bit 4 - "No STD since last power
off" Bit 20 - "Primary nvram memory checksum
error"
Bit 5 - "System Fault" Bit 21 - "Secondary nvram memory
checksum error"
Bit 6 - "Totalizer locked" Bit 22 - "Primary and secondary nvram
checksum error"
Bit 7 - "Standardization difference" Bit 23 - "NV Write Error"
Bit 8 - “HART communication error” Bit 24 - “#1 Totalizer locked”
C-2 DensityPRO with F
OUNDATION
™ fieldbus Application Guide Thermo Fisher Scientific