Thermo Scientific DensityPRO, Application Manual

Page: 98 / 101

Index
F
fieldbus, 1-1 , B-3
connector, 2-1
jumper settings, 2-2
parameters for DensityPRO, C-1–C-16
system connections, 2-1–2-2
troubleshooting, 9-1
FLOW_VOLUME_UNIT, C-10
FOUNDATION fieldbus
introduction, 1-1–1-3
system connections, 2-1–2-2
H
HEAD_TYPE, C-10
HV_CTL, C-10
I
I/O. See inputs, outputs.
inputs
contact closure, 1-3
overview, 1-3
specification, B-2
IOUT_HOLD_VALUE, C-10
IOUT_MAX_CORRECTION, C-10
IOUT_MIN_CORRECTION, C-10
IOUT1_VALUE, C-10
IOUT1_VALUE_PERCENT, C-10
J
jumper settings
for fieldbus board, 2-2
L
LAST_STD, C-10
link master, 1-2
loop test, 8-2 , E-11
LUMP_STATUS, C-10
M
MAN. See manual mode
manual mode, 3-9
MASS_FLOW_TIME_UNIT, C-10
MASS_FLOW_UNIT, C-10
MATERIAL_TYPE, C-10
MAX_IOUT_VALUE, C-10
MEA_NUM_AT_CURRENT_OUT_ALTMODE, C-11
MEA1_READ, C-11
MEA1_READOUT, C-11
MEA1_UNIT, C-12
MEA2_READ, C-12
MEA2_READOUT, C-12
MEA3_READ, C-12
MEA3_READOUT, C-12
MEA4_READ, C-13
MEA4_READOUT, C-13
MEASURE1_AT_MAX_IOUT, C-13
MEASURE1_AT_MIN_IOUT, C-13
MEASURE2_AT_MAX_IOUT, C-13
MEASURE2_AT_MIN_IOUT, C-13
MEASURE3_AT_MAX_IOUT, C-13
MEASURE3_AT_MIN_IOUT, C-13
MEASURE4_AT_MAX_IOUT, C-13
MEASURE4_AT_MIN_IOUT, C-13
menus, 3-10–3-11
Actions, 7-1
Alarms, 6-1–6-2
Density Setup, 3-10
Diag/Service, 3-10 , 8-1–8-4
Gauge Calibration, 5-2–5-3
Setup, 4-1–4-6
Standardization, 5-1–5-2
methods. See menus.
MIN_IOUT_VALUE, C-13
N
NI-FBUS Configurator, 3-1–3-16
node address, 3-4
NUMBER_OF_RELAYS, C-13
O
OOS. See out of service mode
ordering information, A-1–A-2
other meas assign & modify, 4-6 , E-5
INDEX-2 DensityPRO with F
OUNDATION
™ fieldbus Application Guide Thermo Fisher Scientific