Thermo Scientific DensityPRO, Application Manual

Page: 71 / 101

DensityPRO Specific Parameters
Parameter Type R/W Description
DATA_REF_CNT_RATIO S R The data/ref count ratio.
DAYS_GAUGE_ON CON R/W The number of days the gauge is on in one week.
DENSITY_CAL_POINT1 CAL R/W The density at calibration point 1.
DENSITY_HOLD_MODE CON R/W The hold value for the density measurement.
DENSITY_SLOPE CAL R/W Density slope.
DETECT_SIG_VALUE S R The internal value of the detector signal.
DPRO_CMD CMD R/W Commands that can be issued to the DensityPRO.
Ready Select alternate time constant
Hold current output Select primary time constant
Clear all alarms Erase all entries (EVERYTHING)
Start CAL cycle Restart
Hold current output at maximum
setting Erase all alarm action assignments
Hold current output at minimum
setting Hold current output at FAULT LOW
Clear ALL holds Start Standardization
Hold density at density hold mode
value Switch current out to alt/pri mode
Hold current output at FAULT HIGH Abort standardization
Start system test Erase protected NVRAM
Use latest CAL value for CAL point 1 Refresh
DRY_BULK_DENSITY_FOR_
FLOW_MEAS CON R/W The dry bulk density for flow measurement (shown if bulk solids flow selected for
MEA1_READ, MEA2_READ, MEA3_READ, or MEA4_READ.
FLOW_VOLUME_UNIT CON R/W The volume units for the flow measurement.
2 = cubic meter
4 = cubic feet
5 = cubic yard
6 = gallon
10 = liter
HEAD_TYPE CON R/W The source head type.
1 = 5190 source head
2 = 5191 source head
3 = 5176 source head
4 = 5200 source head
5 = 5201 source head
6 = 5202 source head
7 = 5203 or 5204 source head
8 = 5211 source head
HV_CTL S R The high voltage control signal.
IOUT_HOLD_VALUE CON R/W The current output hold value.
IOUT_MAX_CORRECTION CON R/W The correction factor for the current output at maximum.
Thermo Fisher Scientific DensityPRO with F
OUNDATION
™ fieldbus Application Guide C-9