Thermo Scientific DensityPRO, Application Manual

Page: 69 / 101

DensityPRO Specific Parameters
Parameter Type R/W Description
ALARM7 ALM R/W Set up alarm triggering point, clear point, and gauge actions when alarm happens for
ALARM7.
Sub-parameter Description
Select the action used to indicate that the alarm has been
triggered. ACTION
0 = Nothing
1 = Control relay 1
2 = Control relay 2
3 = Output 1 to FAULT LOW
5 = Output 1 to FAULT HIGH
SET_POINT The process level at which the alarm will activate
Select a clear point (clr point) or dead band (deadband) to clear
the alarm. CLR_MODE
0 = clr point 1 = deadband
CLR_POINT_
DEADBAND Enter clear point or dead band value.
ALARM8 ALM R/W Set up alarm triggering point, clear point, and gauge actions when alarm happens for
ALARM8.
Sub-parameter Description
Select the action used to indicate that the alarm has been
triggered. ACTION
0 = Nothing
1 = Control relay 1
2 = Control relay 2
3 = Output 1 to FAULT LOW
5 = Output 1 to FAULT HIGH
SET_POINT The process level at which the alarm will activate
Select a clear point (clr point) or dead band (deadband) to clear
the alarm. CLR_MODE
0 = clr point 1 = deadband
CLR_POINT_
DEADBAND Enter clear point or dead band value.
BAD_FLAGS_1 BF R Bad flags set 1
Bit 0 - "Bad entry values see details
in setup" Bit 16 - "Invalid Density Slope"
Bit 1 - "No bad data detected" Bit 17 - "Unit has not been standardized"
Bit 2 - "No Bad Entries" Bit 18 - "Flow/Temp use same A/D Chan"
Bit 3 - "Solution Polynomial failed" Bit 19 - "Unit address > 32"
Bit 4 - "Meas 1 is not Density" Bit 20 - "Unused"
Bit 5 - "Meas # Select code includes
flow" Bit 21 - "Unused"
Bit 6 - “Cal den value is not realistic” Bit 22 - “Number of Break Points > 16”
Thermo Fisher Scientific DensityPRO with F
OUNDATION
™ fieldbus Application Guide C-7