DensityPRO Commands
D-2
DensityPRO with
F
OUNDATION
™ fieldbus
Application Guide
Thermo Fisher Scientific
Table D–1.
DensityPRO commands
Command
Description
Ready
The interface is ready for the next command.
Hold current output
Hold the current output at the current output hold
value.
Clear all alarms
Acknowledges, clear, and reset all alarms.
Start CAL cycle
Begin a calibration cycle.
Hold current output at maximum
setting
Hold the current output at the maximum output value.
Hold current output at minimum
setting
Hold the current output at the minimum output value.
Clear ALL holds
Clear all holds that are currently active.
Hold density at density hold mode
value
Hold the density at the density hold mode value.
Hold current output at FAULT HIGH
Hold the current output at the FAULT HIGH level.
Start system test
Causes the unit to test the various types of memory,
the data integrity, and the signal processor. The system
performs an automatic test and verification function
every 10 minutes, and all user-entered data is double
stored and periodically cross-checked. Errors are
automatically corrected, and an alarm is activated
when an error is detected.
Use latest CAL value for CAL point
1
Use the latest CAL value as CAL point 1.
Select alternate time constant
Switch to the alternate time constant
(TC_ALTERNATE).
Select primary time constant
Switch to the primary time constant (TC_PRIMARY).
Erase all entries (EVERYTHING)
Erase all configured data.
Restart without power cycling
Restart the system without cycling power.
Erase all alarm action assignments
Erase entries for alarm assignments to relays, current
output, etc.
Start standardization
Begin a standardization cycle.
Hold current output at FAULT LOW
Hold the current output at the FAULT LOW level.
Switch current out to alt/pri mode
Switch the current output to alternate/primary mode.
Abort standardization
Stop the currently running standardization cycle.
Erase protected NVRAM
Erase NVRAM.
Refresh
Refresh the data in the fieldbus interface.
Summary of Contents for DensityPRO
