Thermo Scientific DensityPRO, Application Manual

Page: 63 / 101

Appendix C
DensityPRO Specific Parameters
The fieldbus parameters that are specific to the DensityPRO are
categorized as follows:
●
Command parameters: Used to issue commands to the device.
●
Status parameters: Display the internal status of the DensityPRO.
●
Configuration parameters: Used to configure the DensityPRO’s
operational modes.
●
Alarm parameters: Used to set up the gauge alarms.
●
Calibration parameters: Used to linearize gauge performance.
●
Alarm and Status Flags: Display information on the state of the
alarm.
●
Bad Flags: Indicate the cause of incorrect gauge configuration.
The parameter types are indicated in the table according to the
abbreviations below.
CMD: Command S: Status
CON: Configuration ALM: Alarm
CAL: Calibration ASF: Alarm and Status Flag
BF: Bad Flag
All DensityPRO parameters are located in the AI_TRANSDUCER block
(AITB).
Note To make locating a parameter easy, they are listed alphabetically. ▲
Caution Take care when modifying parameters directly. If you change the
value for one parameter, you may need to change the value for other
parameters.
▲
Thermo Fisher Scientific DensityPRO with F
OUNDATION
™ Fieldbus Application Guide C-1