Unit Operation with TG-VI Controller
55
Selecting CYCLE-SENTRY or
Continuous Mode
NOTE: The CYCLE-SENTRY icon will appear when the
CYCLE-SENTRY mode is selected and the
O
N
/O
FF
switch is
in the
O
N
position.
Continuous Mode:
When Continuous mode is selected, the
unit will run continuously to maintain the setpoint and provide
constant airflow.
CYCLE-SENTRY Mode:
:
When the CYCLE-SENTRY
Mode is selected, the unit starts and stops automatically as
required to maintain the setpoint and to keep the engine warm
and the battery charged.
1.
The unit must be turned on. Clear all alarms.
2.
Press the
S
ELECT
key (cycling arrows) until the display
shows CYCLS and YES or NO.
3.
Press the
U
P
or
D
OWN
keys to choose
YES
or
NO
.
YES
operates the unit in CYCLE-SENTRY.
NO
operates the
unit in Continuous Run.
4.
Press the
E
NTER
key (equals sign) when the desired mode
is shown in the display.
NOTE: The
E
NTER
key must be pressed within 10 seconds to
load the new mode.
The display will briefly show
Lod
(load) and then the new
mode will appear.
1.
Select Key
3.
Down Key
2.
Up Key
Figure 24: Selecting CYCLE-SENTRY
or Continuous Mode
ANA11
1
3
2
Unit Operation with TG-VI Controller
55
Selecting CYCLE-SENTRY or
Continuous Mode
NOTE: The CYCLE-SENTRY icon will appear when the
CYCLE-SENTRY mode is selected and the
O
N
/O
FF
switch is
in the
O
N
position.
Continuous Mode:
When Continuous mode is selected, the
unit will run continuously to maintain the setpoint and provide
constant airflow.
CYCLE-SENTRY Mode:
:
When the CYCLE-SENTRY
Mode is selected, the unit starts and stops automatically as
required to maintain the setpoint and to keep the engine warm
and the battery charged.
1.
The unit must be turned on. Clear all alarms.
2.
Press the
S
ELECT
key (cycling arrows) until the display
shows CYCLS and YES or NO.
3.
Press the
U
P
or
D
OWN
keys to choose
YES
or
NO
.
YES
operates the unit in CYCLE-SENTRY.
NO
operates the
unit in Continuous Run.
4.
Press the
E
NTER
key (equals sign) when the desired mode
is shown in the display.
NOTE: The
E
NTER
key must be pressed within 10 seconds to
load the new mode.
The display will briefly show
Lod
(load) and then the new
mode will appear.
1.
Select Key
3.
Down Key
2.
Up Key
Figure 24: Selecting CYCLE-SENTRY
or Continuous Mode
ANA11
1
3
2
Summary of Contents for SB-200TG
