Unit Operation with TG-VI Controller
49
Starting the Diesel Engine
Turn the On/Off switch to the On position. If no key is pressed,
the engine will automatically preheat and start in about 10
seconds. If a key is pressed (to change setpoint or view display
screens), the engine will automatically preheat and start about
10 seconds after the last key is pressed.
If the unit is in CYCLE-SENTRY mode and cooling, heating
or defrosting is required, the engine will automatically preheat
and start.
WARNING: When the On/Off switch is in the On
position, the unit may start at any time without prior
warning.
WARNING: Never use starting fluid.
Unit Operation with TG-VI Controller
49
Starting the Diesel Engine
Turn the On/Off switch to the On position. If no key is pressed,
the engine will automatically preheat and start in about 10
seconds. If a key is pressed (to change setpoint or view display
screens), the engine will automatically preheat and start about
10 seconds after the last key is pressed.
If the unit is in CYCLE-SENTRY mode and cooling, heating
or defrosting is required, the engine will automatically preheat
and start.
WARNING: When the On/Off switch is in the On
position, the unit may start at any time without prior
warning.
WARNING: Never use starting fluid.
Summary of Contents for SB-200TG
