Unit Operation with TG-VI Controller
62
3.
To reset the alarm system.
a.
Press the
S
ELECT
KEY
to display the alarm screen.
b.
Press the
E
NTER
KEY
to clear the alarm. Enter must be
pushed to clear each alarm if more than one alarm is
present
After all alarms are cleared, the alarm symbol will
disappear. After about ten seconds, the standard display
will appear on the screen.
NOTE: If the alarm condition is not corrected, alarms may
continue to appear.
Alarm code 74 requires an authorized service technician to
reprogram the TG-VI.
Unit Operation with TG-VI Controller
62
3.
To reset the alarm system.
a.
Press the
S
ELECT
KEY
to display the alarm screen.
b.
Press the
E
NTER
KEY
to clear the alarm. Enter must be
pushed to clear each alarm if more than one alarm is
present
After all alarms are cleared, the alarm symbol will
disappear. After about ten seconds, the standard display
will appear on the screen.
NOTE: If the alarm condition is not corrected, alarms may
continue to appear.
Alarm code 74 requires an authorized service technician to
reprogram the TG-VI.
Summary of Contents for SB-200TG
