TG-VI Controller Description
41
NOTE: If a DAS is installed, the unit must be on for
approximately 15 seconds with no keypad keys pressed for the
microprocessor to confirm the presence of the DAS.
S
ELECT
Key (Continued)
[Hr6]: :
Hourmeter 6 hours. Displays only if
hourmeter 6 is enabled.
[oIL]:
Engine oil pressure.
[EnT]:
Engine coolant temp.
[rPn]:
Engine revolutions per minute.
[bAt]:
Battery voltage.
[coL]:
Coil temperature.
[dS1]-[dS6]:
Up to six DAS sensors.
Displays only if DAS is connected.
[dFI]:
Defrost interval in range.
[dFn]:
Defrost interval not in range
[ddr]:
Defrost duration.
U
P
Key:
On the Standard Display screen, it
increases the setpoint. On other screens, it
changes the displayed prompt or other setting.
D
OWN
Key:
On the Standard Display screen,
it decreases the setpoint. On other screens, it
changes the displayed prompt or other setting.
E
NTER
Key:
Enters new temperature
setpoints and initiates or enters other settings.
TK L
OGO
Key:
Initiates unit self check and
displays software revision. Also used to print
a trip report and initiate a start of trip on units
equipped with a DAS.
TG-VI Controller Description
41
NOTE: If a DAS is installed, the unit must be on for
approximately 15 seconds with no keypad keys pressed for the
microprocessor to confirm the presence of the DAS.
S
ELECT
Key (Continued)
[Hr6]: :
Hourmeter 6 hours. Displays only if
hourmeter 6 is enabled.
[oIL]:
Engine oil pressure.
[EnT]:
Engine coolant temp.
[rPn]:
Engine revolutions per minute.
[bAt]:
Battery voltage.
[coL]:
Coil temperature.
[dS1]-[dS6]:
Up to six DAS sensors.
Displays only if DAS is connected.
[dFI]:
Defrost interval in range.
[dFn]:
Defrost interval not in range
[ddr]:
Defrost duration.
U
P
Key:
On the Standard Display screen, it
increases the setpoint. On other screens, it
changes the displayed prompt or other setting.
D
OWN
Key:
On the Standard Display screen,
it decreases the setpoint. On other screens, it
changes the displayed prompt or other setting.
E
NTER
Key:
Enters new temperature
setpoints and initiates or enters other settings.
TK L
OGO
Key:
Initiates unit self check and
displays software revision. Also used to print
a trip report and initiate a start of trip on units
equipped with a DAS.
Summary of Contents for SB-200TG
