Themis RES-32XR3/FIO, Installation Manual

Page: 48 / 142

RES-32XR3/FIO Installation Manual
2-2
Themis Computer
1. Loosen the four captive Phillips screws holding the protective top access
cover to the rear of the RES-32XR3/FIO chassis (see
A , Figure 2-1 ).
2. Both the front and sides of the cover have flat hooks or tabs underneath that
fit under slots on the chassis top edges (see
B , Figure 2-1 ). Remove the cover
by sliding it toward the rear until it is free of these chassis slots.
3. Store the cover in a safe place until it is replaced.
4. Proceed to the appropriate section to install or replace a memory module
(page 2-3), PCI card (page 2-7), or lithium battery (page 2-8).
Figure 2-1. Remove the RES-32XR3/FIO Protective Access Cover
Loosen the 4 captive access-cover screws...
A
B
Rear View
... and slide the top cover toward the rear until the top hooks and tabs clear all chassis slots
Chassis slot
Chassis slot
Left-side top edge