Textron Cessna 172S Skyhawk SP, Information Manual

Page: 81 / 491

SECTION 4
NORMAL PROCEDURES
CESSNA
MODEL1728
.
,
15. Annunciator ,Panel Test Switch :- H!=LEASE'; Check that ap-
propriate annunciators remain on.
I.' ."
11>,
When Master Switch is turned ON, some annunciators will
flash for approximately. 10 .seconds before illuminating.
steadily. When panel TST switch is toggled up and held in
position, all remaining lights will flash until the switch is
released. •
16. Fuel Selector Valve -- BOTH.
17. Fuel Shutoff Valve •. ON (Push Full In).
18. Flaps -- EXTEND.
.
19. Pitot Heat -- ON. (Carefully check that pitot tube is warm to
touch within 30 seconds.)' . .
20. Pitot Heat -- OFF.. .
21. Master Switch -- OFF'. ';,'
1
22. Elevator Trim -' SET for takeoff.
23. Baggage Door -- CHECK, lock with key ...
24. Autopilot
Static Source Opening (if installed)-- CHECK for
blockage. . • •.
CP
EMP~NNAGE ."
"f ," ~ ~-
1. Rudder Gust Lock (if installed) -- REMOV!=.'
2. Tail Tie-Down -- DISCONNECT.
3, Control
Surfaces -- CHECK freedom of movement and
security.
4. Trim Tab •. CHECK security. . .
5. Antennas _. CHECK for'security of attachment and general
condition ..
G>
RIGHT WING Trailing Edge
1. Aileron •• CHECK freedom of movement and security.
2. Flap -- CHECK for security and condition.
G)
RIGHT WING
1. Wing Tie-Down -- DISCONNECT .
.4.8
Revision 4