teutonia BeYou, Operating Instructions Manual

Page: 11 / 78

ÉLÉGANCE
10
INT
How to
Push the
sponding
Attentio
end of th
er is als
If you ne
the rear
insert pi
the open
for venti
Adjustin
Adjustin
Lift the f
Caution
the footr
the adju
Using th
You can
Always u
your chil
on the b
the free
Removing the hood cover
Both hood bars must be re-
moved from the cover before
washing. (See illustration)
Loosen the screw using a
screwdriver and remove the
press stud. Now pull the cover
bar out of the joint and out of
the hood cover. After wash-
ing, reassemble in reverse or-
der.
When doing this, make sure that each cover bar is
pushed into both stitched guides. The front and back
bars must not be mixed up.
Unfolding the Chassis
Pull up the folding handle 1
(hand grip) up as far as it
will go. The handle lock
2 en-
gages and the arrester lever
3 automatically moves over
the tube as an additional
safeguard.
WARNING: Ensure that
all the locking devices
are engaged before
use.
Folding the Chassis
Press the two unlocking but-
tons on both sides
1 , so that
the frame can be folded to-
gether. Release the arrester
lever
2 (by raising it) and swiv-
el the handle over to the oth-
er side. You can reduce the
storage size further by folding
down the top of the handle.
Assembling and removing the wheels
Before assembling or remov-
ing the wheels, press the
locking spring
1 . When as-
sembling the wheels, make
sure that the locking spring
engages properly.
Seat cover
The seat cover can be completely removed from the seat
unit in order to be washed. To do this, press the press
studs on the seat unit.
Attention: When fitting the seat cover, please pull the
end of the 5-point harness back through the matching
openings without twisting it.
Height-Adjustable, Foldable Handle
To change the height of the
handle, press in the adjusting
buttons on both sides of the
handle.
Applying the Parking Brake
The brake is activated by
pushing down the long brake
lever
1 . If it is difficult to ap-
ply the brake, wheel the
stroller back and forth a few
centimetres so that the brake
bars engage properly in the
wheel rim. Make sure that
the brake has locked secure-
ly. You can release the brake
by depressing the brake lever 2 .
Attaching and removing the seat or
carry-cot (upper section)
Place the upper section (seat or carry-cot) onto the pram
chassis in such a way that the lateral bars
1 of the upper
section click into the slots provided 2 on each side of the
chassis and push the upper section in as far as it will go.
The locks then close automatically. (The locks must
"click" into place.)
WARNING:
Check that the pram body or seat unit at-
tachment devices are correctly engaged be-
fore use.
The upper section is secure if the red field in
the release lever is no longer visible. To remove the up-
per section press the safety lever
(3) up and then the re-
lease lever (4) down until the lever locks. (red field ap-
pears). Then pull the upper section out of the slots and
remove it.
4 3
Elegance-In_148x210 05.09.12 13:49 Seite 10