Terex Genie Z-45/25 Bi-Energy, Service Manual

Page: 99 / 213

Part No. 237062 Z-45/25 Bi-Energy • Z-45/25J Bi-Energy 4 - 27
September 2015 Section 4 • Repair Procedures
Kubota Z482-E2B and
Z482-E3B Engines
6-1
Timing Adjustment
Complete information to perform this procedure is
available in the
Kubota Z482-E2B Workshop
Manual (Kubota part number 97897-01165).
Kubota Z482-E3B Operator's Manual
(Kubota part number 1G689-89160).
Kubota Z482-E2B Workshop Manual
Genie part number 52956
Kubota Z482-E3B Operator's Manual
Genie part number 139420
6-2
RPM Adjustment
See the scheduled maintenance procedure B-8,
Check and Adjust the Engine RPM.
6-3
Engine Drive Pulley
How to Remove the Engine Drive
Pulley
1 Remove the engine pivot plate latch retainer.
2 Open the engine pivot plate latch and swing the
engine out away from the machine to access
the engine drive pulley.
3 Loosen the tension adjustment bolt on the
generator.
4 Pull the generator away from the machine and
remove the belts from the generator pulley.
5 Remove the 3 bolts that attach the engine drive
pulley to the shaft bushing.
6 Install the same 3 bolts that were removed in
step 5 into the threaded holes of the engine
drive pulley.
7 Carefully tighten each bolt evenly until the
engine drive pulley slides off the shaft.
Component damage hazard. The
engine drive pulley and/or shaft
can be damaged if the bolts are
not tightened evenly.
8 Loosen the set screw on the pulley bushing,
then slide the pulley bushing off of the engine
shaft.
a gap
b shaft
c set screw
d engine drive pulley
e engine drive pulley bolt
f shaft bushing
g woodruff key
a
c
a
e e
f
g
b
d d f