![background image](http://html.mh-extra.com/html/terex/genie-z-45-25-bi-energy/genie-z-45-25-bi-energy_service-manual_1088715110.webp)
4 - 38
Z-45/25 Bi-Energy • Z-45/25J Bi-Energy
Part No. 237062
September 2015
Section 4 • Repair Procedures
9-2
Valve Adjustments -
Function Manifold
How to Adjust the System
Relief Valve
Note: Perform this procedure with the boom in the
stowed position.
1 Connect a 0 to 5000 psi / 0 to 350 bar pressure
gauge to the test port on the function manifold.
2 Move and hold the function enable toggle switch
to either side and hold the primary boom
extend/retract toggle switch in the retract
direction with the primary boom fully retracted.
Observe the pressure reading on the pressure
gauge. Refer to Section 2,
Specifications
.
3 Turn the machine off. Hold the system relief
valve with a wrench and remove the cap
(item O).
4 Adjust the internal hex socket. Turn it clockwise
to increase the pressure or counterclockwise to
decrease the pressure. Install the relief valve
cap.
Tip-over hazard. Do not adjust
the relief valve higher than
specified.
5 Repeat steps 2 through 4 and recheck relief
valve pressure.
MANIFOLDS
How to Adjust the Secondary
Boom Down Relief Valve
Note: Perform this procedure with the boom in the
stowed position.
1 Connect a 0 to 5000 psi / 0 to 350 bar pressure
gauge to the test port on the function manifold.
2 Move and hold the function enable toggle switch
to either side and hold the secondary boom
up/down toggle switch in the down direction
with the secondary boom fully lowered.
Observe the pressure reading on the pressure
gauge. Refer to Section 2,
Specifications
.
3 Turn the machine off. Hold the secondary boom
down relief valve with a wrench and remove
the cap (item W).
4 Adjust the internal hex socket. Turn it clockwise
to increase the pressure or counterclockwise to
decrease the pressure. Then install the relief
valve cap.
Tip-over hazard. Do not adjust
the relief valve higher than
specified.
5 Repeat steps 2 through 4 and recheck relief
valve pressure.
Summary of Contents for Genie Z-45/25 Bi-Energy
