Part No. 237062
Z-45/25 Bi-Energy • Z-45/25J Bi-Energy
3 - 9
September 2015
Section 3 • Scheduled Maintenance Procedures
3 Check to be sure the engine pulley and the
generator pulley are aligned within specification
using a straightedge. Refer to Section 2,
Specifications
.
a
engine pulley
b
straightedge
c
maximum pulley offset
d
generator pulley
Note: If alignment does not meet specification,
refer to Repair Procedure 6-3,
How to Install the
Engine Drive Pulley
to adjust the pulley alignment.
CHECKLIST
A
PROCEDURES
c
b
a
d
A-4
Check the Generator Belts and
Pulleys
Maintaining the generator belts and the pulleys is
essential to good engine performance and service
life. The generator will not operate properly with
loose or defective belts and continued use may
cause component damage.
Bodily injury hazard. Do not
inspect while the engine
is running. Remove the key to
secure from operation.
Bodily injury hazard. Beware of hot
engine components. Contact with
hot engine components may cause
severe burns.
Note: Charging the batteries with the engine does
not fully charge the batteries. Periodically, use the
AC battery charger to fully charge the batteries.
1 Be sure that all fasteners and cables on the
generator are tight.
2 Be sure that the pulley mounting fasteners are
tight and that the pulleys show no signs of
damage or unusual wear.
Summary of Contents for Genie Z-45/25 Bi-Energy
