FSP200
19
Tempo Communications Inc.
1390 Aspen Way • Vista, CA 92081 USA • 800-642-2155
6
SM
For splicing standard single-mode fiber (ITU-T G652).
The MFD is 9 to 10 µm at wavelength of 1310 nm.
User can edit all parameters of this splice mode such as prefuse power, prefuse time, arc
power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work in this
splice mode.
7
DS
For splicing dispersion-shifted fiber (ITU-T G653).
The MFD is 7 to 9 µm at wavelength near 1550 nm.
User can edit all parameters of this splice mode such as prefuse power, prefuse time, arc
power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work in this
splice mode.
8
NZ
For splicing non-zero dispersion-shifted fiber (ITU-T G655).
The MFD is 9 to 10 µm at wavelength of 1550 nm.
User can edit all parameters of this splice mode such as prefuse power, prefuse time, arc
power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work in this
splice mode.
9
MM1
For splicing multi-mode fiber (ITU-T G651). Core diameter: 50.0 to 62.5 µm.
User can edit all parameters of this splice mode such as prefuse power, prefuse time, arc
power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work in this
mode.
10
AT1(SM)
User can set the attenuation value in the range of 0.1 to 15 dB.
Set the desired splice loss. If after the splice is completed the desired loss is not achieved,
the user can adjust the splicing coefficient. Increasing the coefficient will increase the desired
loss; decreasing the coefficient will reduce the splice loss.
11
SM FAST
For splicing standard single-mode fiber (ITU-T G652).
The MFD is 9 to 10 µm at wavelength of 1310 nm.
This mode process does not analyze fiber geometry.
12
SM G657
For slicing standard Bend Insensitive single-mode fiber (ITU-T G657).
The MFD is 9 to 10 µm at wavelength of 1310 nm.
User can edit allthe parameters of this splice mode such as prefuse power, prefuse time, arc
power, arc time, align, proof test, etc.
The manual splicing operation is provided. Automatic arc calibration does not work in this
splice mode.
13~60
BLANK
(other modes)
User can assign these as their own custom splicing profiles.
Splice Mode Menu
(S–Mode)
Explanation of Splice Modes
(cont’d)